A 1-head fogger allows many horticultural applications, it will diffuse a dry mist which, not wetting the leaves, will prevent mold and disease. It will be useful for maintaining the hygrometry in the greenhouse, for cooling the plants during high heat, for the growth of young cuttings.

High humidity during growth limits insect attacks, strengthens the foliage which is maintained in perfect working order for photosynthesis.

Its flow rate is 80 to 90 ml per hour of fog diffusion.

This fogger will be used at a depth of 5 to 6 cm of water. It will be useful for regulating temperature and humidity in greenhouses and indoor gardens.

The operation of a fogger is very simple, the ceramic cell vibrates at very high frequency (3 times the speed of sound) and agitates the water molecules.

These molecules, smaller than 5 microns then turn into mist. This dry mist that will not run off the leaves will prevent mold and disease development.

The mist also absorbs odors.

A fogger is not made to operate continuously, but in intermittent ON/OFF periods. To do this, we advise you to connect it to a programmer on a cycle of 15 minutes on and 15 minutes off.

• The temperature of the water for its proper functioning must be between 5°C and 40°C.
• The ideal water level is 10mm above the top of the sensor probe.
• Use a container large enough so you don't splash out of it.
• Do not use abrasive products to clean the Mist Maker.
• Do not expose the transformer to moisture.

Features of Ultrasonic Humidifier / Fogger 1 head

- 20mm membrane
- Fog diffusion capacity: 90ml/hour
- Water consumption: ≥ 500ml/hour
- Water level required: 30-50mm (from ceramic surface)
- Water temperature limit: +5ºC to +40ºC
- Cable length: 1.5m

Contents of the shipment

- Ultrasonic air humidifier
- User manual
- AC/DC power adapter

Important Note:

To ensure the longevity of the device, use only demineralised water, distilled water, osmosis water or rainwater.

It is necessary to use the float Compatible with the humidifier.